PIV Unit Installation

Guide · Homeowners · 3 min read · Updated 17 November 2026

How Much Does a PIV Unit Cost to Install in the UK?

Short answer

A loft-mounted PIV unit typically costs £650–£1,100 supplied and fitted in the UK, including the unit, heater, diffuser, ducting and connection to an existing power supply. A wall-mounted unit for a flat costs £750–£1,250 because of core drilling. A new fused spur in the loft adds £120–£250 if needed. Servicing and filter changes start from £90.

How Much Does a PIV Unit Cost to Install in the UK?

Typical PIV prices in 2026

PIV installation is normally quoted as a fixed job. The price covers the unit itself, the diffuser, a short run of flexible ducting, mounting hardware, connection to the electrical supply, setting the airflow for your home and clearing up. The table shows guide prices for supply and fitting by a competent installer. They assume reasonable loft access, a loft hatch large enough for the unit and an existing power supply within reach.

Prices vary with the model you choose. Basic units with a simple heater sit at the lower end, while units with humidity sensing, a wall controller, adjustable summer settings or a larger fan for bigger homes sit higher.

ItemGuide priceNotes
Loft-mounted PIV, supplied and fitted£650–£1,100Standard house unit with heater and diffuser
Wall-mounted PIV for flats£750–£1,250Includes core drilling, grille and making good
New fused spur in the loft£120–£250Only if no suitable supply is nearby
Extract fan replacement£180–£350Humidity-controlled or continuous fan, ducted out
PIV service and filter changefrom £90Filter, clean, heater check, airflow adjustment
Condensation assessment visitfrom £75Humidity readings and diagnosis of cause

What affects the price

The type of property is the first factor. A house with a boarded loft and a convenient spur is the quickest and cheapest install. A flat needs a wall-mounted unit, which means core drilling through an external wall, fitting a sleeve and external grille and making good inside, so it costs more and takes longer.

Electrics are the next swing. Many lofts have no socket or spur near the unit position, so a new fused connection has to be run, and this must be done to BS 7671 by a competent electrician. Finally, awkward access adds labour: small or high hatches, unboarded lofts, low headroom and thick insulation all slow the job.

  • Loft-mounted unit versus wall-mounted unit with core drilling
  • Unit features such as heater, humidity sensing and wall controller
  • Whether a new electrical spur is needed
  • Loft hatch size, boarding and headroom
  • Extra work such as upgrading bathroom or kitchen fans

Running costs after installation

A PIV fan is designed to run continuously at low speed, and the fan motor uses very little electricity, broadly comparable to a low-energy light bulb on normal settings. The bigger variable is the tempering heater. It only switches on when incoming air falls below a set temperature, so in a mild winter it runs rarely, while in a cold spell it may run more often.

Your installer can set the heater trigger point to balance comfort and cost. Many owners find the house also heats up more quickly once humidity drops, because drier air feels warmer and takes less energy to warm.

Ongoing maintenance costs

PIV units need very little maintenance. The main task is changing the filter at the interval the manufacturer recommends, which depends on the model and how dusty your loft is. Some units show a reminder light. Replacement filters are inexpensive, and many homeowners change them themselves if they can reach the unit safely.

A professional service, from £90, adds a clean of the fan and diffuser, a check of the heater and wiring and an airflow adjustment. It is worth booking if the unit has become noisy, the diffuser feels draughty or condensation has crept back. Older units without a heater, or with worn bearings, are often better replaced than repaired. A replacement in the same position is usually quicker than a first install, because the diffuser hole and power supply already exist, which can keep the cost towards the lower end of the range.

Is a PIV unit worth the money?

For homes where condensation and mould come from high indoor humidity and poor background ventilation, a PIV unit is one of the most cost-effective fixes. It treats the whole house rather than one room, runs without anyone remembering to switch it on and avoids emptying dehumidifier tanks. Compared with repeated mould treatment, redecorating and replacing damaged belongings, the installation often pays for itself in avoided costs.

It is not worth fitting for damp caused by leaks, rising damp, bridged cavities or failed pointing. Those need fixing at source first. That is why a short assessment is sensible before buying a unit.

Getting a fixed price

The best quotes follow a quick look at your home. The installer checks the loft or external wall, the electrics, the layout of the landing or hallway for the diffuser and the condition of your existing extract fans. They may take humidity readings to confirm condensation is the real cause. You then get one all-in price for the agreed model and work.

We arrange assessments and installation through vetted, insured local installers across the UK. Send a quote request with your property type and the rooms affected, and we will come back with a fixed price.

  • Tell us whether you have a loft or live in a flat
  • Mention which rooms show condensation or mould
  • Note whether there is a socket or spur in the loft

Questions people also ask

Is a PIV unit cheaper than MVHR?

Yes, much cheaper. A PIV unit is a single fan and diffuser fitted in a few hours, while mechanical ventilation with heat recovery needs ducting to every room and is best suited to new builds or major refurbishments. For an existing home with condensation, PIV is usually the practical and affordable option.

Do I need an electrician to fit a PIV unit?

The unit must be connected safely to the mains, and any new spur or circuit must be installed to BS 7671. Some work is notifiable under Part P in England and Wales. Many PIV installers are qualified to do this themselves; otherwise an electrician completes the connection as part of the job.

Does the quoted price include removing my old unit?

Usually, if the installer knows about it in advance. Removing an old PIV unit, blanking or reusing the existing diffuser hole and disposing of the old fan adds a little time. Mention it in your quote request so the fixed price covers everything and there is nothing extra on the day.

Written and checked by the PIV Unit Installation team. Read our editorial policy.

Get a free piv unit installation quote

Tell us what you need and we'll come back with a clear price.

Request a quote