PIV Unit Installation FAQs
Straight answers to the questions we're asked most.
What is a PIV unit?
A PIV unit is a positive input ventilation fan that supplies fresh, filtered air into a home, usually from the loft through a ceiling diffuser on the landing. It creates gentle positive pressure that pushes moist, stale air out through natural gaps. This dilutes humidity and reduces condensation and mould without needing windows open.
Does a PIV unit really stop condensation?
A correctly sized and set PIV unit reduces condensation in most homes where the cause is high indoor humidity and poor ventilation. Results usually show within a few weeks. It will not fix damp caused by leaks, rising damp or failed pointing, so those need repairing separately. Working extract fans in kitchens and bathrooms help it work best.
How much does it cost to run a PIV unit?
The fan in a typical PIV unit uses very little electricity, comparable to a low-energy light bulb, so running costs are small. The heater, if fitted, adds cost when it switches on during cold weather, which is why its trigger temperature can be adjusted. Your installer can explain the settings and expected running costs for your chosen model.
Will a PIV unit make my house cold?
A PIV unit should not make a house noticeably colder when set correctly. Loft air is usually warmer than outside air, and many units have a heater that tempers incoming air in cold weather. Drier air also feels warmer and heats up faster. If the diffuser feels draughty, the installer can lower the speed or adjust the heater setting.
Can you fit a PIV unit in a flat?
Yes, flats use a wall-mounted PIV unit that draws air directly from outside through a cored hole in an external wall. It works on the same principle as a loft unit. In a block of flats, you will usually need the freeholder's or managing agent's permission to drill the external wall, so check your lease first.
How long does PIV installation take?
A loft-mounted PIV unit usually takes two to four hours to install, including fitting the unit, cutting the diffuser, running ducting and connecting power. Wall-mounted units in flats take a little longer because of core drilling and making good, typically three to five hours. Adding a new electrical spur can add an hour or two.
Where should a PIV diffuser go?
The diffuser should go in a central position on the landing or in the hallway ceiling, so fresh air can spread to every room. Avoid placing it directly above a bed, in a small closed room or in a corner. In bungalows, the central hallway is usually best. A good installer chooses the spot after looking at the layout.
Are PIV units noisy?
Modern PIV units are quiet on normal settings, usually producing a soft whoosh at the diffuser rather than fan noise. Anti-vibration mounts in the loft stop hum travelling through joists. Units can become noisy if set too high, if ducting is kinked or if bearings wear with age. Most noise problems are fixed by adjusting the speed or replacing an old unit.
Do I still need extract fans if I have PIV?
Yes, extract fans in kitchens and bathrooms are still important with PIV. They remove moisture at source, while PIV dilutes humidity across the rest of the house. Building Regulations require adequate extraction in wet rooms. If your existing fans are weak or not ducted outside, upgrading them alongside a PIV unit gives much better results.
How often does a PIV filter need changing?
Most PIV filters need changing every few years, depending on the model and how dusty the loft is; check the manufacturer's guidance. A clogged filter reduces airflow and makes the fan work harder. Some units show a reminder light. Replacement filters are inexpensive and many homeowners change them themselves, or book a service visit.
Does a PIV unit help with mould?
A PIV unit helps prevent mould by lowering indoor humidity, so surfaces stay drier and mould finds it harder to grow. Existing mould should be cleaned off with a suitable mould treatment, because PIV will not remove it. Over time, with the home drier, regrowth is far less likely. Persistent patches may point to a cold spot or leak.
Can I turn off a PIV unit in summer?
You can, but most PIV units are designed to run continuously all year at low speed. Many have a summer bypass or temperature cut-off that stops pushing hot loft air into the house on warm days. Turning it off for long periods lets humidity build up again. Ask your installer about the summer setting on your model.
Get a free piv unit installation quote
Tell us what you need and we'll come back with a clear price.
Request a quote