Guide · Homeowners · 3 min read · Updated 17 November 2026
Loft vs Wall-Mounted PIV: Choosing the Right Unit for Your Home
Short answer
Choose a loft-mounted PIV unit if you live in a house or bungalow with an accessible loft; it uses warmer loft air and typically costs £650–£1,100 fitted. Choose a wall-mounted unit if you live in a flat or have no usable loft; it draws air from outside through a cored hole and costs £750–£1,250. In a block, you usually need the freeholder's permission to drill the external wall.
Loft-mounted PIV units
The loft-mounted unit is the standard choice for houses and bungalows. It sits on a cross-beam or hangs from a rafter on anti-vibration mounts, with a short flexible duct to a round diffuser cut into the ceiling below. The loft acts as a pre-heater because its air is usually warmer than outside, especially on sunny days, and the unit's heater only tops up on cold days.
Installation takes around two to four hours. You need a loft hatch large enough to pass the unit through, safe boarding near its position and a power supply nearby, or a new fused spur.
- Suits houses, bungalows and top-floor flats with their own loft
- Uses pre-warmed loft air
- Usually the lower-cost option
- Needs safe loft access and a nearby power supply
Wall-mounted PIV units
Flats, maisonettes and houses with converted lofts use a wall-mounted unit. The installer core-drills a hole of around 100 to 150mm through an external wall, usually in a hallway, fits a sleeve sealed through the cavity and an external grille, then mounts the unit inside. Air comes straight from outside, through a filter, and is warmed by the built-in heater when needed.
Because outside air is colder than loft air, heater settings matter more for comfort. Installation takes three to five hours, including making good. Care is needed around cavity insulation, wiring and any services in the wall.
Side-by-side comparison
The right choice is mostly decided by your property. Where both are possible, the loft unit is usually simpler and cheaper.
| Factor | Loft-mounted | Wall-mounted |
|---|---|---|
| Guide price fitted | £650–£1,100 | £750–£1,250 |
| Air source | Loft space | Outside, through external wall |
| Typical install time | 2–4 hours | 3–5 hours |
| Heater reliance | Lower | Higher in winter |
| Permissions | Rarely needed | Often needed in blocks of flats |
| Visible inside | Ceiling diffuser only | Wall unit in hallway |
Flats, leases and permissions
In a leasehold flat, the external walls usually belong to the freeholder, so drilling through them typically needs the freeholder's or managing agent's written consent. Check your lease before booking. Some blocks have rules on the position and colour of external grilles, and listed buildings or conservation areas may need further permission for visible changes to the outside.
Social and private tenants should speak to their landlord, who is responsible for the building fabric. A landlord dealing with condensation complaints will often welcome a straightforward, low-maintenance fix.
Diffuser placement, heaters and controls
With a loft unit, the diffuser should sit centrally on the landing or in the hallway ceiling, so air can spread to every room through door gaps. Avoid placing it over a bed, inside a small closed room or in a corner. In bungalows, the central hallway is usually best. Wall units are placed similarly, in a central hallway rather than a bedroom.
Feature choice comes next. A built-in heater is worth having in almost every home. Adjustable summer settings stop hot loft air being pushed in on warm days. Humidity sensing and wall controllers let the unit increase airflow when moisture rises.
- Central diffuser position, clear of doors to wet rooms
- Tempering heater with adjustable trigger temperature
- Summer setting or temperature cut-off
- Optional humidity sensing or wall controller
Sizing the unit to the home
PIV units are set up for the volume of the home, not just the number of rooms. A two-bedroom bungalow needs far less airflow than a three-storey townhouse, and most units have adjustable speed settings so one model can cover a range of sizes. Larger homes may need a higher-capacity model to move enough air on a comfortable, quiet setting rather than running a small unit flat out.
Layout matters as well. Open stairwells spread air easily, while long corridors, split-level floors and rooms behind closed doors need more thought. In some larger or unusually shaped homes, installers position the diffuser to favour the worst-affected rooms. The commissioning visit should finish with the airflow set and explained, so you know which setting the unit should stay on.
Booking an assessment
A short visit settles which unit suits your home. The installer checks the loft or external wall, the electrics, the position for the diffuser or unit and your existing extract fans, then confirms the model and one all-in price. They will also look for signs that the damp has another cause, such as staining after rain or tide marks on ground-floor walls, so you are not sold a unit that cannot help.
We arrange this through vetted, insured local installers across the UK. When you request a quote, tell us your property type, whether you have a usable loft, which rooms are affected and whether you own the freehold or need consent from a freeholder or landlord.
Questions people also ask
Can I have a loft PIV if my loft is converted?
Usually not in the converted area, because the unit needs an unheated loft void to draw from. If there is a remaining eaves space or small loft above the conversion, a unit may fit there. Otherwise, a wall-mounted unit on an external wall is the normal alternative.
Will a wall-mounted unit let rain into the wall?
Not when installed properly. The core-drilled hole is lined with a sleeve sealed through the cavity, and a weatherproof external grille sits over the opening. The sleeve stops moisture tracking across the cavity. Ask your installer how they seal the sleeve before work starts.
Is a wall-mounted PIV unit noisy?
Modern wall units are quiet on normal settings, producing a gentle airflow sound rather than motor noise. Because the unit is inside the living space rather than in a loft, it is worth choosing a quiet model and setting the speed correctly. Fitting it in a hallway rather than a bedroom helps.
Written and checked by the PIV Unit Installation team. Read our editorial policy.
More guides
How Much Does a PIV Unit Cost to Install in the UK?
A loft-mounted PIV unit typically costs £650–£1,100 supplied and fitted in the UK, including the unit, heater, diffuser, ducting and connection to an…
Does Positive Input Ventilation Work? How PIV Stops Condensation
Yes, positive input ventilation works well where condensation and mould are caused by high indoor humidity and poor ventilation. The unit pushes…
PIV vs Dehumidifier vs MVHR: Which Is Best for Condensation?
For whole-house condensation in an existing home, a PIV unit is usually the best value: one unit, fitted in a few hours, running continuously with…
Damp and Mould in Rented Homes: A Landlord's Guide to PIV Units
Landlords in England must keep rented homes free from serious hazards under the Housing Health and Safety Rating System, which includes damp and…
Get a free piv unit installation quote
Tell us what you need and we'll come back with a clear price.
Request a quote